adhesion strength
英 [ədˈhiːʒn streŋθ]
美 [ədˈhiːʒn streŋθ]
粘合强度；粘附强度
双语例句
- The influence of nanoparticles on the adhesion strength between epoxy resin and steel substrate
纳米颗粒对环氧树脂胶粘剂／钢铁附着强度的影响粘着分子，粘附分子 - A series of Aluminium silicate gunning refractories and its properties, such as thermal shock resistance, adhesion strength, were measured.
配制系列硅酸铝质喷补料并检测其抗热震性及喷补附着性能等。 - The effect of Ti-doping and stress relaxation layer on adhesion strength of DLC thin film
Ti掺杂及Ti应力缓和层对类金刚石薄膜附着力的影响 - Rubber and plastics-Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength
GB/T12833-1991橡胶和塑料撕裂强度及粘合强度多峰曲线的分析方法 - Interfacial adhesion strength of composite is characterized by the methods of torsional braid analysis. To braid or twist ( hair) into a queue.
使用扭辫分析对复合材料界面粘合强度进行了表征。 - Theoretical Calculation on Adhesion Strength of Non occupying Coating to Sand Core
非占位涂料与砂芯附着强度的理论计算 - The result showed that the proper dosage of the silane was3%, the excessive amount of silane will lead to structural defects of the material, so the adhesion strength decreased.
研究表明，有机硅单体的最佳用量为3%，过量的有机硅会导致材料结构缺陷，从而影响粘接强度。 - Fabrication and Characteristic Analysis of Solidly-mounted Film Bulk Acoustic Resonator Development of one-component de-ketoxime type silicone sealant with good adhesion strength
固态封装型的体声波谐振器的制备与性能分析单组分高粘接强度脱酮肟密封胶的研制 - Influence of Formula on Adhesion Strength of Silicone Rubber/ Stainless Steel
配方对硅橡胶/不锈钢粘接强度的影响 - Steel cord conveyor belts& Adhesion strength test of the cover to the core layer
GB/T17044-1997钢丝绳芯输送带覆盖层与带芯层粘合强度试验方法 - The designer should consolidates the experience, adopt the formula rationally and calculate the internal-power, compressive and adhesion strength accurately.
工程实践中，设计者应当总结经验，对锚筋内力、桩承载力和粘结力采用合理公式并准确计算。 - The fracture of the pins was caused by improper assembly flow and lower adhesion strength of the fixing glue.
装配方式不合理，固定胶粘接强度不足和工艺不完善是导致引脚断裂的原因。 - Causes for poor adhesion strength of electroplated coating to ABS plastic and their controls
ABS塑料与电镀层结合力差的原因分析及其控制 - Application of orthogonal method in adhesion strength treatment of stainless steel coloring
正交试验法在不锈钢着色硬化处理中的应用 - Cyanide-free pre-immersion can improve covering power and throwing power as well as the adhesion strength of coating.
无氰预浸可提高镀液深镀能力与分散能力，及镀层结合力。 - Lower water vapor partial pressure during processing for higher quality, better adhesion and more reproducible deposition. The effect of Ti-doping and stress relaxation layer on adhesion strength of DLC thin film
改善镀膜的质量，提高薄膜的附着力和多层镀膜能力。Ti掺杂及Ti应力缓和层对类金刚石薄膜附着力的影响 - Study on adhesion strength of argon plasma treatment of modified PTFE
氩等离子体处理聚四氟乙烯粘接性能研究 - The peel and the adhesion strength of various solidification fraction of the ETPB were studied.
本文研究ETPB固化剂加入量对粘接和剥离强度的影响。 - Research of Improving Adhesion Strength Between Polyurethane Interlayer and Directional PMMA Plate
聚氨酯胶片与有机玻璃界面粘结强度的研究 - The effects of depositing temperature on the thickness, adhesion strength and hardness of TiN film have been studied in this paper.
研究了沉积温度对膜层的厚度、结合力及硬度的影响。 - The properties of conversion film, such as corrosion resistance and adhesion strength to different coatings, were studied.
研究了膜层的耐蚀性及其与不同漆膜之间的附着力。 - Evaluation of Adhesion Strength of High-Strength Coating by Symmetrical-Incision Tensile Testing and Analysis of Its Plane Stress bv Finite Element Method
对称切口拉伸法评价高强度涂层及平面应力有限元分析 - Because of low bonding strength of glue, conventional stretching method cannot be used to evaluate the adhesion strength of high-strength coatings.
由于粘胶结合强度的限制，常规拉伸法不能用于评价高强度涂层。 - Adhesion strength of diamond films on cemented carbide were evaluated by Rockwell indentation tests.
扫描电镜观察表面金刚石形貌，洛氏硬度压痕法评价涂层结合情况。 - The "Scotch tape test" was designed to measure the adhesion strength of the metal coating to the PET fabric.
采用自主设计的透明胶带法测量金属与织物纤维的结合力。 - The influence of basis material on the adhesion strength of the diamond film coated tools has been stud-ied.
研究了基体材料对金刚石薄膜涂层刀具附着强度的影响。 - The adhesion strength development between PCM and commen cement mortar has been studied in this test.
本文研究了聚合物水泥砂浆（PCM）与普通水泥砂浆之间的粘接强度。 - The adhesive has higher adhesion strength than the conventional two-component PU adhesive used for laminating leather.
与常用的复合革用双组分聚氨酯胶粘剂相比，该胶粘剂具有较高的粘接强度。 - The results show that it is related to viscosity, stability, dry speed, adhesion strength.
结果表明，这些因素对胶粘剂的粘度、稳定性、干燥速度和粘贴强度有很大的影响。 - The influence of support surface pretreatment was studied on the adhesion strength between zeolite crystals and stainless steel support.
考察了不锈钢载体表面处理对分子筛与载体之间结合力的影响。